Rheem Heat Pump Installation Nationwide | Dalton Heating & Air Long Beach

Rheem Heat Pump Installation in Long Beach: What to Know First

A Rheem heat pump installation in Long Beach typically runs $3,500 – $7,500 depending on the model line, home size, and whether ductwork needs modification. We install Rheem heat pumps as an independent Rheem service provider, which means we’re not restricted to one product line and we’re not padding the job with manufacturer-mandated markups. Most Rheem installations take one to two days from the time equipment lands in our shop to the final startup test. If you’re weighing a Rheem installation, calling (562) 512-7423 gets you a written price before any work starts, no exceptions. This page is for Long Beach homeowners who already own a Rheem system or are leaning toward Rheem for a replacement and want to know what the job actually involves before the first tech shows up.

Call (562) 512-7423

How Rheem Products Fail – and How We Fix Them

Rheem makes solid equipment, but every line has its weak points. After years of turning wrenches on Rheem systems across Long Beach, here’s what we actually see in the field.

• Rheem Classic Series (RP14/RP15) – reversing valve sticking. The reversing valve is the part that flips the system between heating and cooling. On Classic Series units, we see the valve body gum up with refrigerant oil sludge, especially on systems that sat unused through a full Long Beach heating season. The fix is a valve replacement and a full refrigerant recovery, not a band-aid recharge. Heat pump installation of a new unit sidesteps this entirely if the old one is already on borrowed time.
• Rheem Prestige Series (RP17/RP20) – defrost sensor failure. Prestige units use an electronic defrost control board with a thermistor that reads outdoor coil temperature. When that sensor drifts, the unit defrosts when it shouldn’t or doesn’t defrost at all, and you get a coil frozen solid on a 55-degree Long Beach night. We replace the sensor and update the board firmware, which is a service call most contractors skip because they don’t carry the part. We do.
• Rheem Endeavor Line (RD17AZ/RD15AZ) – communication wiring issues. Endeavor’s EcoNet communication system talks between the thermostat and the outdoor unit over low-voltage wiring. If that wire run has a nick or a corroded splice, the system throws communication errors and locks out. Long Beach salt air near Alamitos Bay and Naples Island accelerates that corrosion. We run new shielded control wire rather than patching the old run, because a heat pump installation is only as good as the signal path controlling it.
• Rheem outdoor units – compressor contactor pitting. This one spans multiple lines. The contactor is the electrical switch that sends power to the compressor. After a few years of Long Beach humidity cycles, the contact points arc and pit, and the compressor starts chattering or fails to start. It’s a $150 – $300 repair on most Rheem units. We check contactor condition as part of every heat pump installation retro-fit and on every service call.
• Rheem heat pumps – improper previous installation causing TXV failure. The thermostatic expansion valve (TXV) meters refrigerant into the indoor coil. We find more failed TXVs on Rheem systems that were installed by someone who skipped the nitrogen purge during brazing. The copper oxide scale from that shortcut clogs the valve screen. Our installers purge with nitrogen on every single connection, every single time. That’s not optional. It’s The Garrison Standard.

Our Rheem Heat Pump Installation Process

Here’s what a Rheem heat pump installation looks like when you call Dalton Heating & Air Long Beach.

1. 1
   You call (562) 512-7423. A live person answers, day or night. You tell us what the system is doing, and we schedule a diagnostic visit inside a window you actually agree to, not a four-hour vague range.
2. 2
   We diagnose the existing system. We check refrigerant pressures, electrical draw, airflow, and the condition of the ductwork. If the existing Rheem unit is repairable, we tell you that first. If replacement is the honest call, we explain why with the test numbers in front of you.
3. 3
   We write a fixed price. Before any equipment is ordered or any work starts, you get a line-item written quote. The price includes the equipment, any duct modifications, permits where required, the electrical disconnect, and the haul-away of the old unit. No surprises at the door.
4. 4
   We install to spec. We pull a vacuum to below 500 microns to remove moisture and non-condensables from the line set. We purge with nitrogen during brazing. We set the refrigerant charge by subcooling, not by guesswork. We verify airflow at each supply register. Marco Benitez grew up in East Los Angeles and learned the trade at Los Angeles Trade-Technical College, and he still checks charge and airflow on every Rheem heat pump installation personally before it’s signed off.
5. 5
   We test in both modes. A heat pump has to heat and cool. We run the system in cooling mode, then switch it to heating and verify the reversing valve shifts, the defrost cycle works, and the auxiliary heat strips if equipped kick in correctly. Most installers skip the heating test on a cool day. We don’t.
6. 6
   We leave the site clean and hand you the guarantee. Written guarantee on the full installation, in your hand, before we drive off. If it fails within a year, we return at no charge. That’s the 365-Day Done Right Promise, and it’s been the standard at every Garrison Partners location since 2003.

What Rheem Heat Pump Installation Costs in Long Beach

A full Rheem heat pump installation in Long Beach lands between $3,500 and $7,500. Here’s how that breaks down in the real world:

• Basic Rheem Classic Series heat pump, no ductwork changes: $3,500 – $4,800
• Rheem Endeavor Line with EcoNet thermostat and minor duct sealing: $4,800 – $6,200
• Rheem Prestige Series with variable-speed air handler and duct modification: $6,200 – $7,500

What moves the price: whether your existing ductwork is sized correctly for a heat pump, whether the electrical panel has room for a new dedicated circuit, and whether the line set needs to be extended or re-routed. Older Long Beach homes near Bluff Park with original 1950s ductwork run toward the higher end. We give you the exact number in writing before work begins, and the estimate is free. Call (562) 512-7423 for a written quote on your specific home.

Why Long Beach Homeowners Call Dalton Heating & Air Long Beach for Rheem Work

We’re factory-trained on nine major residential HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. So when a Rheem system needs work, we’re not guessing our way through a brand we see twice a year. We see Rheem units every week from Signal Hill to El Dorado Park, and we know which parts fail on which models. Every job gets a written price before work starts. Every repair carries a written guarantee for a full year. If the work fails in that time, we come back at no charge. Our techs are background-checked, uniformed, and they arrive inside the window we set. The Garrison Code has been the operating rule since 2003: arrive on time, price in writing, do the job by the book, leave the site clean, and stand behind the work for a year. We don’t ask you to take that on faith. It’s on the work order.

FAQs